REVELL Control Nano Quad Fun XS

Need help?

Do you have a question about the REVELL Control Nano Quad Fun XS and is the answer not in the manual?

Summary

Turn on the remote control and then the model, followed by initialization for connection.

Place the model on an even horizontal surface to allow control electronics to align.

Initiate flight by pressing the start button for automatic ascent to a low altitude.

Safely land the model by pressing the landing button for automatic descent and motor shutdown.

Control ascent and descent by moving the left joystick forward or backward.

Navigate forward, backward, left, and right using the right joystick.

Rotate the model left or right by moving the left joystick left or right.

Execute aerial loops by briefly pressing the right joystick down vertically.

Change flight speed by briefly pressing the left joystick down vertically.

Monitor battery status via LED blinking, indicating low power and need for landing.

Adjust trim by pressing the button in the opposite direction of model drift.

Differentiate propellers by markings (A/B) before fitting them onto the shafts.

Carefully pull off defective propellers and fit new ones onto the shafts.

Check ON/OFF switch position and battery charge if propellers fail to spin.

Ensure the battery is adequately charged if the model unexpectedly stops or descends.

Verify power, battery insertion, and charge levels for proper remote control connectivity.

Correct propeller arrangement if the model does not lift off or rolls over.

General