EasyManua.ls Logo

REVELL Performa C30 - Page 16

REVELL Performa C30
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SYSTEM OPTIMIZATION (CONT’D)
2. The REVEL PERFORMA C30 center-channel loudspeaker
must be used with an 80 Hz crossover as follows:
• If your system includes a multi-channel controller, set the
center channel to use an 80 Hz crossover. Some controllers
or receivers refer to this setting as a “small” center channel.
• Use an 80 Hz crossover even if your system does not include
a subwoofer. In its absence, the multi-channel controller or
receiver will use “bass management” techniques to route the
frequencies below 80 Hz to the front left and right channels.
As a result, no center-channel low-frequency information
will be lost.
• The use of an 80 Hz crossover will result in dramatically
decreased distortion, accurate timbre, and greatly increased
dynamic capability.
• Please contact your Revel dealer for assistance in properly
adjusting the crossover settings on your multi-channel
controller or receiver.
3. Initially set the PLACEMENT COMPENSATION control (see
Figure 16 on previous page) to match the application as follows:
• Use the Flush Mounted setting when the loudspeaker is
flush-mounted in a wall or custom-built “media wall,” or is
placed on a bookshelf.
• Use the On Top of Monitor setting when the loudspeaker is
placed on top of a rear projection or direct view monitor.
• Use the Stand Mounted setting when the loudspeaker is
placed on its (optional) pedestal.
4. Turn on the system power and play a variety of material. Slowly
increase the volume to a comfortable level and listen from your
main listening position. Be sure to set your multi-channel con-
troller to a mode that utilizes the center channel. If the REVEL
PERFORMA C30 loudspeaker is used in a home theater system,
listen to well-recorded dialog from more than one film, as the
sound quality can vary greatly.
5. Experiment with setting the PLACEMENT COMPENSATION
control. It provides a powerful means to correct for the place-
ment effect on the REVEL PERFORMA C30’s “timbre,” or
overall balance. Due to the influence of room acoustics, you
may achieve a better timbre match with the left and right
(front) loudspeakers than your original setting (as performed
REVEL PERFORMA C30
Owner’s Manual
16