REVOV R200 - User Manual

R200 51.2V 200Ah 10.24kWh 2
nd
LiFe PO
4
The REVOV R200 is a 2
nd
LiFe 16cell, 51.2V, 200Ah, 10.24kWh, Battery Module with built-in BMS with CANBus
communications. Where inverter communications are required the unit’s CAN bus communications provides
State of Charge and other information to supported inverters. In installations where no communications to
the inverter are required the REVOV 2
nd
LiFe R200 can act as a lead-battery replacement. Automotive grade
2
nd
LiFe cells and REVOV 16 cell technology deliver superior performance under all loads assembled to meet
the highest standards of SAFETY, RELIABILITY and LONGEVITY.
It is the perfect choice to provide backup power and integrate into Solar systems where daily cycling of the
system is desired. It is common to install just one battery to deal with blackouts but grow the system later.
More batteries can be added easily onto a shared busbar for those reducing their grid power usage in a
phased approach. The REVOV 2
nd
LiFe R200 can be orientated with the “face”to the front, top or side for
convenient wall and 19”rack mounting.
8. Do not strike, throw, or subject the battery to sever physical shock.
9. Do not directly solder the battery terminals.
10. Do not attempt to disassemble or modify the battery in any way.
11. Do not place the battery in a microwave oven or pressurized container.
12. Do not use the battery in combination with primary batteries (such as dry cell batteries) or batteries
of different cell count, cell-capacity, type, or brand.
13. Do not use the battery if it gives off an odour, generates heat, becomes discoloured or deformed,
or appears abnormal in any way. If the battery is in use or being recharged, remove it from the
device or charger immediately and discontinue use.
14. Do not dispose the battery before completely discharge.
15 Do not charge the battery by charging voltage over 57.0V.
16. Do not charge the battery by a charger with an automatic desulfation mode function
(equalization).
17. Pleasexthebatteryterminalwithoriginalscrewsandnutssecurely.Batterymaybedamagedby
the sparks because of the loose connections.
18. Keep out of reach of Children and Pets.
Transport Concerns
1. Thebatteryshouldbetransportedwith70%chargestate(approx.).
2. The battery should be packed with insulation and shockproof material to avoid damage from
sudden jolts and collision.
3. The battery should be handled with care when loading and unloading during transport.
Do not throw the batteries and avoid collision.
4. Donottransportthebatteriestogetherwithammable,explosiveobjects,orsharpmetalgoods.
Storage
5. Thebatteryshouldbestoredwith50%chargestate(approx.).
6. The battery should be stored in a clean, dry,and ventilated environment (20-30°C), not in contact
withanycorrosivesubstanceandawayfromheatandfire.
7. The battery should be charged completely once every 180 days when in storage.
The battery pack comprises multiple systems that are designed to prevent hazards resulting from
failures. However, due the nature of electrical systems, REVOV cannot guarantee their absolute safety.
Leaking Batteries
Ifthebatterypackleakselectrolyte,avoidcontactwiththeleakingliquidorgas.Ifoneisexposedtothe
leaked substance, immediately perform the actions described below.
8. Inhalation: Evacuate the contaminated area and seek medical attention.
9. Contactwitheyes:Rinseeyeswithowingwaterfor15minutesandseekmedicalattention.
10. Contact with skin: Wash the affected area thoroughly with soap and water, and seek
medical attention
11. Ingestion: Induce vomiting, and seek medical attention.
Fire
Incaseofres,makesurethattheextinguisherisavailablenearthebatterypack.Ifpossible,movethe
batterypacktoasafeareabeforeitcatchesre.Note:FireExtinguisherWater,carbondioxide,dry
chemicalpowderandfoamarethemosteffectivemeanstoextinguishaLithiumFerrousPhosphate(LFP)
batteryre.
WARRANTY
REVOV Batteries (PTY) LTD:
10 years or 3 500 cycles at 1 cycle per day.
DOD
When used properly every day the R200 can be safely discharged to 100% of its rated 200Ah capacity.
Battery life is shortened if it is discharged beyond its rated Ah capacity.
Package Domensions (mm)
Model
9(Externallabel) Type L H
W Weight
R200 51.2V LiFePO
4
200Ah 620 520 300 86kg
Equipment Excl. Packaging (mm)
REVOV Product Code: Type L H W Weight
2LIFE-R9-UBMS-R200-10.2 51.2 battery 520 442 221 83.6kg
Technical Specications
General Settings Dependent on inverter type Notes
Inverter Voltage (V) Settings
Float Charge 54.5V
Absorption 55-55.6V
Load and temperature
dependent
Bulk/Boost/
Absorption Charge
55.5V
Low Voltage
Disconnect
46.5V
MaximumChargecurrent(A)
@25°C ambient 100A
Recommended Charge current (A) 60A Recommended
Max.DIschargeCurrentContinuous
(A)
160A
125A In-line fuse
recommended
Recommended Recharge time (h) 3h
Even60Aissufcient
recommended
Charging Temperature (°C) 10-35°C
Max output power (W) 7500W
Total Energy (kWh) 10.2kWh
Nominal voltage (V) 51.2V
Capacity (Ah) 200Ah
Scalability
Up to 15
Batteries in parallel

REVOV R200 Specifications