Revox C270

Extended operation
LOOP mode
Note:
HRS MIN
mo 0
Leb, bee, La
SEL STEP TRANS SEARCH RESET
a
= = = -= -=
Z4L0C ALOC LOOP T-DUMP EDIT
PLAY STOP REC
MIN SEC
i os I
w=. 1 I
om « “om
SEL STEP TRANS SEARCH RESET
= = Ld] = -
ZLOC ALOC LOOP T-DUMP_ EDIT
PLAY STOP
In LOOP mode it is possible to automatically
repeat the playback of a certain tape segment
or the entire tape. Proceed as follows:
@ At the position where the loop is to start, set
the tape counter to zero by pressing the RE-
SET [12] key.
@ Enter the ending address of the loop into the
A-LOC as described under “Locator func-
tion”.
@ Press the LOOP [15] key. The yellow LED
above this key lights up; the recorder positions
atthe tape address 12.24.35 and starts in play
mode. When the ending loop address stored
in the A-LOC is reached, the tape rewinds au-
tomatically and the entire process is repeated
until cancelled.
The LOOP function can be cancelled by se-
lecting a tape transport function (<<, >>,
PLAY, STOP) or by pressing the Z~LOC or A-
LOC key. The selected function will be execut-
ed immediately.
If the tape address stored in the A-LOC is ne-
gative, the play mode starts at the address
stored in the A-LOC and ends at tape address
00.00.00.
19