23
Troubleshooting/FAQ
Date/Time Stamp not
appearing on images
Make sure that the Time Stamp parameter is set
to ‘On’.
PIR Sensor LED Flashes/
Doesn’t Flash
1. When the camera is in the TEST mode, a
special LED on the front of the camera will
flash when it senses motion.This is for setup
purposes only and will help the user aim the
camera.
2. During use, the LED will not flash when the
camera takes an image. This is to help keep
the camera hidden from game.
Camera won't retain
settings and doesn't
flash
Make sure that you have been saving the changes
to any parameter settings that you made while in
Setup mode, by pressing OK after changing the
setting.
Moisture or Ants inside
Camera
1. To ensure humidity or rain is kept out of the
camera, secure the DC In plug firmly in place.
2. Ants can be attracted by low level electronic
vibrations, and enter through any gaps between
the exterior and interior of the camera. Make
sure the DC In plug is securely attached.
To Next Page
Loading...