Reyco Granning IFS1700S

Questions and Answers

J
Jonathan ThompsonAug 18, 2025
How to fix quick or uneven tire wear on Reyco Granning IFS1700S?
- Z
  zwangAug 18, 2025
  Quick tire wear or uneven tread on your Reyco Granning Automobile Accessories can stem from several issues. It might be due to incorrect tire pressure, so ensure you inflate your tires to the specified pressure. Other potential causes include imbalanced tires (balance or replace them), incorrect toe-in or ride height (adjust to the specified settings), misaligned rear axle (align to the specified thrust angle), incorrect steering arm geometry (adjust tie rod lengths), or using mismatched tires and wheels (install the correct combination).
J
James DaviesAug 30, 2025
How to stop excessive rolling in my Reyco Granning IFS1700S Automobile Accessories vehicle?
- C
  carolynhodgesAug 30, 2025
  Excessive side-to-side rolling in your Reyco Granning Automobile Accessories vehicle can be attributed to several factors. Worn front and/or rear shock absorbers are a common cause, so replace them as needed. Check for loose shock mounting and tighten as required. Inspect the shock eye bushings and sway bar bushings for wear, and replace them if necessary. Also, ensure that the sway bar mounting brackets are properly tightened. Worn control arm pivot bushings can also contribute to this issue, so inspect and replace them as needed. Lastly, check for internal leaks in the height control valve and replace it if required.
S
smithjenniferSep 2, 2025
Why do the front tires lock up on my Reyco Granning IFS1700S Automobile Accessories?
- B
  brett34Sep 2, 2025
  If the front tires of your Reyco Granning Automobile Accessories lock up during hard braking, or if the ABS malfunction light stays on, there are a few things to check. Start by inspecting the ABS sensor installation and replace the sensor if necessary. There could be an ABS CPU or system malfunction, so check and repair or replace as required. Also, check the ABS sensor electrical connection and lead wire for any faults. Finally, inspect the tone ring on the hub for damage and replace it if needed.
B
bradley11Sep 5, 2025
What causes a harsh ride in my Reyco Granning Automobile Accessories vehicle?
- G
  gonzalezamandaSep 5, 2025
  A harsh ride or excessive suspension contact in your Reyco Granning Automobile Accessories vehicle can stem from several causes. Worn front shock absorbers are a common culprit, so consider replacing them. Ensure that the ride height is set to the specified setting. Overloading the vehicle can also lead to a harsh ride, so check and correct the wheel loads. Inspect the air spring supply lines for leaks or obstructions and address as needed. Verify that the vehicle system air pressure is within specification. Lastly, check the rebound bumper and jounce bumper in the air spring for wear or damage, and replace if necessary.
L
Larry SmithSep 7, 2025
Why is the ride too soft on my Reyco Granning Automobile Accessories vehicle?
- C
  Christopher HuffmanSep 7, 2025
  If your Reyco Granning Automobile Accessories vehicle's ride feels too soft, consider these potential causes: worn front shock absorbers (replace as required) or incorrect ride height (adjust to the specified setting).
B
Benjamin FletcherSep 9, 2025
Why does my Reyco Granning IFS1700S Automobile Accessories vehicle have an unequal turning radius?
- Q
  qcontrerasSep 9, 2025
  Unequal turning radius in your Reyco Granning Automobile Accessories vehicle can be due to several factors. Incorrect steering arm geometry is a potential cause, so adjust the tie rod lengths as needed. The steering gear might not be centered, so inspect and adjust it. Also, check if the steering gear poppet valves are set incorrectly and adjust the wheel turn angles accordingly. Finally, ensure that the tie rod clamps are positioned properly and adjust their orientation as required.
M
Mark Graves Jr.Sep 12, 2025
Why won't the suspension on my Reyco Granning IFS1700S Automobile Accessories maintain ride height?
- A
  Antonio GriffinSep 12, 2025
  If the suspension on your Reyco Granning Automobile Accessories does not maintain ride height, there are several possible causes. An air leak is a common issue, so check connections with a soapy water solution and repair or replace as needed. There could also be an internal leak in the height control valve, so check and replace if required. Additionally, inspect the height control valve linkage for looseness and tighten as necessary. Lastly, check the air spring for chafing or wear and replace it if needed.
E
Erika OneillSep 14, 2025
What causes noisy brakes on Reyco Granning IFS1700S Automobile Accessories?
- A
  Amy ChapmanSep 15, 2025
  Noisy brakes on your Reyco Granning Automobile Accessories can be caused by grease, oil, or dirt on the brake pads (replace as required); glazed brake pads (deglaze or replace as required); unbalanced brake pads (replace with a balanced set); loose or broken brake pads (replace as required); a warped brake rotor (re-machine or replace); or a defective brake rotor (inspect for defects and replace).
D
David MccoyNov 20, 2025
Why is my Reyco Granning IFS1700S Automobile Accessories vehicle difficult to steer?
- S
  Stephen HamiltonNov 20, 2025
  Difficulty steering your Reyco Granning Automobile Accessories can arise from several factors. Check for improper oversized tires or non-uniform tires, and ensure you install the correct tire and wheel combination. Verify that your tires have the specified air pressure. Inspect the steering arm geometry and adjust the tie rod lengths as needed. Look for any binding in the steering arm assemblies, ball joints, tie rod ends, kingpin, steering column linkage, or steering miter box, and lubricate or repair as required. Also, check for steering gear valve binding (inspect, repair, or replace), steering wheel interference with the column (align or adjust), low power steering fluid level (add fluid, tighten connections), insufficient power steering pump pressure (conduct flow and relief pressure ...
C
chavezmarkNov 22, 2025
What to do if my Reyco Granning IFS1700S vehicle wanders side-to-side?
- C
  Christopher CooperNov 22, 2025
  If your Reyco Granning Automobile Accessories vehicle wanders or has loose steering, it could be due to several reasons. The vehicle might be overloaded or unevenly loaded, so check and correct the wheel loads as needed. Improper or mismatched tires and wheels can also cause this issue, so install the correct tire and wheel combination. Ensure the tires have the correct pressure based on the wheel load. Other potential causes include incorrect toe-in or wheel caster settings (adjust to the specified settings), loose tie rod end connections or worn ball studs (inspect and replace if necessary), loose steering arm assembly mounts (tighten to specification), binding or worn steering arm assembly ball joints (inspect and replace if necessary), worn kingpin (check and replace), wheel bearings o...