1
Box Should include:
LNB Arm Assembled with LNB, LED
and Stow Feet
Two (2) Scotch Locks
Two (2) Zip Ties
Four (4) ¼ by 20 Phillips Head Bolts
Four (4) ¼ by 20 Washers
USB Thumb Drive with controller software
Assembly Instructions
1. Elevate your antenna to straight up position.
2. Unplug your controller before working on the antenna. Pull the 12V barrel jack out of the backside of the
controller. The PS LED on the front should turn OFF.
3. Unplug your satellite receiver. The LNB LED should turn OFF.
To elevate your antenna, Turn on the
controller on by pushing the RED
POWER button. Get into the MENU
OPTIONS by pressing the RED POWER
again. From the MENU on your
controller: Push the GREEN button 2
times to OPTION #3 MOVE
ELEVATION. Push the RED POWER
button 1 time to enter MOVE
ELEVATION OPTION.
Then press and hold the green button until
the antenna completely raises into full
upright position as shown in the picture on
the right.
Eagle LNB ARM Swap Instructions
To Next Page
Need help?
General
