RFL Auxiliary Hybrid Chassis RFL Electronics Inc.
March 29, 2005 1 (973) 334-3100
RFL Electronics Inc.
I N S T R U C T I O N D A T A
RFL 9780/9785
Auxiliary Hybrid Chassis
Figure 1. RFL 9780/85 Auxiliary Hybrid Chassis, front view
DESCRIPTION
Hybrids are optional modules for the RFL Powerline Carrier equipment. They may be used to combine
combinations of transmitters and receivers to a single port for connection to line tuning units. There is
an X-Hybrid Module and a Skewed Hybrid Module available. Each of these modules uses the same
basic printed circuit board.
The Auxiliary Hybrid Chassis shown in Figure 1 is used to add X-Hybrid modules or Skewed Hybrid
modules to RFL Powerline Carrier systems. Each Auxiliary Hybrid is contained in a 19-inch chassis
that occupies less than one rack unit of vertical rack space (1.718 inches, or 4.4 cm). Each chassis can
accommodate three Hybrid modules and three Hybrid I/O modules. The Hybrid modules are mounted
in the front of the chassis, and the Hybrid I/O modules are mounted at the rear of the chassis. In a
given chassis the Hybrid modules can be a mix of any combination of X-Hybrid modules or Skewed
Hybrid modules.
UXILIARY HYBRID CHASSI
RFL Electronics Inc.
To Next Page
