9
HEAT PUMP AND TANK ASSEMBLY
STORAGE TANK AND HEAT PUMP MODULE
The heat pump water heater is made of two main components, the storage tank
and the heat pump module. For transport and handling (weight) purposes both
items are shipped separately and designed to be assembled at the installation
site. The water heater must not be operated until both components are
assembled.
HEAT PUMP MODULE
The heat pump module is to be mounted on the top of the storage tank. It is
designed so that it can be lifted to the top of the storage tank by two people. It
is shipped in a box containing two lifting bars that are inserted into the heat
pump module to facilitate lifting.
CAUTION: The heat pump module weighs approximately 48 kg. Use the lifting
bars provided to lift and mount to the top of the storage tank. Good lifting
practice should be followed.
There are two flexible hoses provided inside the heat pump module. The
flexible hoses are to be fixed to the two water fittings on the top of the storage
tank during the assembly procedure.
There are two connection points located on the control board behind the
electrical cover in the heat pump module to which the power cable and tank
sensor cable from the storage tank are connected during the assembly
procedure.
STORAGE TANK
The storage tank must be fully supported by a stable base. The storage tank is
designed to support the heat pump module.
There are two water fittings located at the top of the storage tank to which
flexible hoses from the heat pump module are connected during the assembly
procedure.
A power cable and a tank sensor cable protrude from the top of the storage
tank. These are to be connected to the control board behind the electrical cover
in the heat pump module during the assembly procedure.
To Next Page
Loading...
