Rheem HB Duct Ready Series - Page 19

19
Basic Water Heater Operation
settings
Temperature Display Fahrenheit
Screen Adjustment Lock? No
Beep On Alarm Enabled
EcoNet Network Instance 1
High Temp Adjust Enable No
Elec. Heat Override Time 3 days
settings
Temperature Display Fahrenheit
Screen Adjustment Lock? No
Beep On Alarm Enabled
EcoNet Network Instance 1
High Temp Adjust Enable No
Elec. Heat Override Time 3 days
settings
Temperature Display Fahrenheit
Screen Adjustment Lock? No
Beep On Alarm Enabled
EcoNet Network Instance 1
High Temp Adjust Enable No
Elec. Heat Override Time 3 days
settings
Temperature Display Fahrenheit
Screen Adjustment Lock? No
Beep On Alarm Enabled
EcoNet Network Instance 1
High Temp Adjust Enable No
Elec. Heat Override Time 3 days
Beep on Alarm: The audible Alarm tone can
be disabled during service periods.
To Enabled/Disabled the audible alarm, press
"Enabled" to highlight, then press up/down
buttons to change to Enabled/Disabled.
EcoNet Network Instance: This number can
be set between 1 and 32. Instance is the way
an EcoNet network identies each appliance
of the same model on the network.
To change the instance number, press "1" to
highlight, then change the number pressing
the up/down buttons.
High Temperature Enable: This setting
can be set to “Yes” if a tank temperature
higher than 140°F is desired. This setting will
automatically turn “No” after 10 minutes of
inactivity on the user interface.
To enable or disable temperature adjust, press
"No" to highlight, then press up/down buttons
to change to Yes/No.
Elec. Heat Override Time: This setting can
be set from 1 to 7 days and will return the unit
to the previous (more efcient) mode after the
set number of day is complete.
To set the days, press "3 days" to highlight,
then press up/down buttons to adjust the days.