OPERATION
RC456 02/11 Operation Section 4-13
© 2011 Alamo Group Inc.
OPERATION
Do not operate this Equipment with hydraulic oil or fuel leaking. Oil
and fuel are explosive and their presence could present a hazard. Do
not check for leaks with your hand! High-pressure oil streams from
breaks in the line could penetrate the skin and cause tissue damage
including gangrene. To check for a hose leak, SHUT the unit ENGINE
OFF and remove all hydraulic pressure. Wear oil impenetrable gloves,
safety glasses and use Cardboard to check for evidence of oil leaks. If
you suspect a leak, REMOVE the HOSE and have it tested at a Dealer.
If oil does penetrate the skin, have the injury treated immediately by a
physician knowledgeable and skilled in this procedure.
(SG-15)
• Inspect teeth for looseness, breakeage and
excessive wear. Make sure implement is on
the ground and securely blocked up. Replace
damaged, worn, and missing teeth at the same
time to maintain uniform tine height.
• Remove any hay or other debris which may be
wrapped around the teeth.
• Inspect condition of all hardware. OPS-RK-
0004
• Perform scheduled lubrication as detailed in
the maintenance section.
• Check for corrosion in storage.
• Inspect that the 3-point hitch pins are the
proper size, correctly installed, and secured to
the tractor lift arms with retaining pins inserted.
• Make sure tires and wheel are in good
condition. Make sure the wheel lug nuts are
tight. OPS-RK-0005
To Next Page
Loading...
Need help?
General
