© 2011 Alamo Group Inc.
HAY RAKE PRE-OPERATION Inspection
Rake ID# ________________________ Make____________________
Date_____________________________Shift____________________
Before conducting the inspection, make sure the Tractor engine is off, all
rotation has stopped and the tractor is in park position with the parking
brake engaged. Make sure the Rake arms is resting on the ground or securely
blocked up and all hydraulic pressure has been relieved.
Operator’s Signature:__________________________________________________________
Item
Condition at
Start of Shift
Specific Comments if
not O.K.
REAR RAKE OR BOX RAKE
The Operator’s Manual is in the Canister on the Hay Rake
All Safety Decals are in place and legible
The Tongue/Hitch connection bolts & pins are tight
There are no cracks in Tongue or Hitch
There are no cracks in Loader Arms or Mounts
The Tow chain is secured to the Tractor & Hay Rake
The Wing connection bolts & pins are tight
Transport locks and retaining chains are in good condition
Rake spokes are in good condition and securely attached to
wheels
Rake wheels are securely attached to the frame members
The Hydraulic Cylinders are in good condition
The Hydraulic Cylinder pins are in place & retained
There are no leaking or damaged hoses
There is no evidence of Hydraulic leaks
The tires and wheel(s) are in good condition
Wheel lug nuts are tight
DO NOT OPERATE an UNSAFE TRACTOR or IMPLEMENT
To Next Page
Loading...
Need help?
General
