To Next PageTo Next PageHow to fix an uneven cut with my RHINO Brush Cutter?
If your RHINO Brush Cutter is producing an uneven cut, several factors could be the cause. You might be operating at an excessive ground speed, in which case you should reduce your speed. Alternatively, the blades may be worn, dull, or bent, requiring replacement. Lastly, the mower might not be level from side to side, which needs adjustment.
What to do if my RHINO Brush Cutter is leaving uncut material?
If your RHINO Brush Cutter leaves uncut material, it could be due to excessive ground speed; try reducing it. Another potential reason is that the RPM is too low; ensure you are using full PTO speed.
Why are the blade bolts on my RHINO Brush Cutter working loose?
If the blade bolts on your RHINO Brush Cutter are working loose, it could be due to several reasons. First, ensure the bolts are tightened to 300 ft./lbs. If the bolt hole is elongated or oversized, replace the blade carrier. Lastly, a worn-out locknut should also be replaced.
What causes streaking when using my RHINO Brush Cutter?
If your RHINO Brush Cutter is exhibiting streaking, it might be because the conditions are too wet for cutting; allow the grass to dry before cutting. Another possible cause is dull blades, which should be sharpened or replaced.
Why is my RHINO Brush Cutter not shredding well?
If your RHINO Brush Cutter is not shredding properly, it could be due to excessive ground speed. Raise the front of the mower relative to the rear to hold and circulate material longer. Also, check if you are cutting too high and lower the cutting height if needed.
Why is the gearbox on my RHINO Brush Cutter so noisy?
If your RHINO Brush Cutter's gearbox is noisy, it could be due to low lubricant; check the lubricant level. Rough gears could also be the problem; try running them in or changing them. A worn bearing may also cause noise, requiring replacement.
What to do if my RHINO Brush Cutter is windrowing heavy, lush material?
If your RHINO Brush Cutter is windrowing material that is heavy and lush, raise the front of the mower relative to the rear.
Why is the gearbox on my RHINO Brush Cutter leaking?
If the gearbox on your RHINO Brush Cutter is leaking, it could be due to a damaged oil seal, which needs to be replaced. Alternatively, a bent shaft could be the cause; replace both the oil seal and the shaft in this case. Finally, a rough oil seal race should be addressed by replacing the shaft or repairing the race.
General| Brand | RHINO |
|---|---|
| Model | TW120 FC-0024 |
| Category | Brush Cutter |
| Language | English |
General safety guidelines and practices for operating equipment safely, emphasizing awareness and precautions.
Essential safety measures for operators, including PPE, visibility, ground speed, and PTO safety.
Safety procedures for connecting and disconnecting implements, including driveline safety.
Identifies hazards related to crushing from tractor/implement movement, rollovers, and falling equipment.
Discusses hazards associated with thrown objects from rotary mowers and required shielding.
Safety precautions to avoid being run over by the tractor or equipment, including mounting/dismounting.
Safety warnings regarding entanglement with PTO drivelines and related rotating components.
Overview of operation and safety instructions for the Rhino TW120 Rotary Mower.
Details the essential pre-operation checks for the mower and tractor before use.
Guidelines for safely driving the tractor with the implement attached, including transport speeds.
Comprehensive instructions for operating the tractor and mower in various conditions.
A guide to diagnose and resolve common problems encountered with the mower.
Identifies hazards associated with performing maintenance, repairs, and service on the implement.
