CGR-630_Operators Manual_CHGR-4815-LA_Rev A_111423.docx
11/14/2023 4:55 PM 3 of 4
WARNING AND SAFETY NOTES:
• Battery manufacturers recommend NEW batteries to CHARGE THE BATTERY FIRST BEFORE DRIVING IT. It
takes 2-3 discharge/recharge cycles to balance a NEW battery.
• Never leave the charger unattended when it is connected to its power supply.
• The allowable AC input voltage is 100-240VAC, 50/60Hz. Never connect it to any other voltage.
• Never place the charger and batteries connected to it on any form of flammable surface.
• Never operate the charger in the vicinity of flammable material or gas.
• Do not submerge the charger in liquids.
• Ensure that there is unrestricted airflow to and from the charger's cooling slots. Never place the charger on a
carpet or similar surface.
• Do not overload AC circuits, the charger may need a full 15amp circuit.
• Do not short circuit the terminals.
• Take great care to maintain correct battery polarity. (STICKER ON UNIT HAS WIRE COLOR AND POLARITY)
• Read the battery manufacturer's instructions and adhere to them strictly.
PROP 65:
Recycle Electronic Component
65 WARNING
WARNING: This product contains chemicals known to
the state of California to cause cancer or birth defects
or other reproductive harm.
For more information: www.P65Warnings.ca.gov
To Next Page
Loading...