Ricatech PR85 - Radio Operation; Selecting Bands and Tuning; Antenna Adjustment for Reception; Volume and Auto Turn-Off

Radio Operation
1. Select required band (FM/AM/SW1-SW2) with BAND selector.
2. Turn to required station by rotating the TUNING Control.
3. The built-in AM antenna and the antenna are directional. When receiving FM or SW1-SW2
broadcast, pull out the telescopic antenna in full length; the strongest reception can be achieved by
rotating the set or antenna.
4. Adjust VOLUME control to your listening preference.
5. Set the Fu
nction Selector SLEEP position, Press PLAY Button. The radio will be automatically
Turn off when the tape reaches the end.
6. To turn off the radio, set the function selector to TAPE(OFF) button. Or unplug the plug.
Listening with Headphones(not included)
For private listening, you can use headphones with the unit .Connect the headphones(not included)to
the Headphones jack at the side of the unit .The sound from the speakers is automatically turned off
when headphones are connected to the unit.
P
lay Back Operation
Cassette play
1. Set the Function selector to the TAPE position
2. Press the STOP/ELECT button to open the cassette door. Insert the cassette to the open side faces up.
Close the cassette door.
3. Use the following buttons and controls for cassette play:
PRESS TO
PLAY Begin cassette play
F.FWD Rapidly advance the tape
REWIND Rapidly rewind the tape .
STOP Stop play or release the F.FWD and REW buttons
Auto Stop Feature Tape plays automatically stop when the end is reached .
PAUSE Stop tape play or record. The use of the PAUSE button dose not
disturb the setting for either play or record .
Caution this function should be used for temporary stop during tape
which is recording .Press PAUSE again to resume play .
VOLUME Control Adjust the volume. Slide the control to the right to increase the
volume slide the control to the left to decrease the volume .
Recording from the Built-in Microphone
1.Set the Function Selector to the TAPE position.
2. Insert a blank cassette into the tape compartment.
3.Push down the Record and Play Button. The recording process start. All sound detected
by the microphone will be recorded until the STOP or PAUSE button is pressed, or until
the tape reaches the end.