Ricatech RR500 - Troubleshooting and Specifications; Troubleshooting Guide; Specifications

The following checks will assist in the correction of most problems which you may encounter will
your set. Before going through the check list below first check the following points.
**The power cord must be connected firmly.
Should any problem persist after you have made these check consult your nearest friendly dealer.
TROUBLESHOOTING GUIDE
Symptom
Possible Causes (and Remedies)
Radio Reception
No radio
The function switch is not in the correct
position.
Adjust the VOLUME knob.
Rotate the TUNING knob to find a radio
station.
Switch the AUX IN jack to “OFF”
CD Player Operation
Disc play does not start.
Reload the disc with the label side up.
Clean the disc.
Sound skips
Change the installation location.
Press reset button.
General
Unit not working
The AC power cord is not connected to an
outlet.
Check that the power cord is connecting
firmly.
Turn the power button from the “OFF”
position to “ON” position.
No sound output
Turn VOLUME clockwise.
Press reset button.
Switch the AUX IN jack to “OFF” & remote
RCA cord.
Severe hum or noise
The TV or VTR is too close to the stereo
system.
Separate from the TV or VTR.
SPECIFICATION
POWER CONSUMPTION : 15W
POWER SOURCE : PLEASE REFER
TO THE CAUTION
LABEL ON THE
BACK SIDE OF
UNIT.
LOUD SPEAKER : 2 X 3” 8 Ohms.
ENGLISH - 6