10
5. Press the [TARE] key. To store spec data and advance to the next spec. S1 0 0 0
6. Press the [TARE] key. To store spec data and advance to the next spec. S2 0 0 0
7. Press the [TARE] key. To store spec data and advance to the next spec. S3 0 0 0
8. Press the [TARE] key. The display will show CAL 00
9. No Weight Should Be On Platter. Press the [TARE] key. The display will show - - - - - - - while the
scale calibrates the zero point. When zero is calibrated the display will show
CAL SP
10. Place Capacity Weight On Platter. Press the [TARE] key. The display will show - - - - - - while
the scale calibrates the span. When span is calibrated the scale will return to the weighing mode.
60.00
NOTE: To exit maintenance mode, Press the [REZERO] key at any step except when - - - - - - are
displayed.
5.3. Internal Count Display :
Example : Begin in the weighing mode with the scale showing 0.00
1. Press and hold [REZERO] key, while holding the [REZERO] key, press [TARE] [TARE]
[ON/OFF] then release the [REZERO] key. The display will show all 8’s while holding the
[REZERO] key, when the [REZERO] key is released the scale will be in the Maintenance Mode. The
display will show d5-671.
2. Press the [ON/OFF] key. To display the Internal (Span) Count
3. Press the [ON/OFF] key. To display the Internal (Zero) Count
4. Press the [ON/OFF] key. To display the Internal(Span) Count
5. Press the [TARE] key. To store spec data and advance to the next spec. S1 0 0 0
To Next Page
Loading...
Need help?
General
