GTR058 Movement Issue
The gate(s) will open but not close, or close but not open
The gate arm does not open/close fully
One gate will open and close but the other will not
Possible Causes
1. Incorrect bracket mounting positions (Refer fig 1 & 2)
2. Incorrect mounting procedure (Refer fig 3)
3. Incorrect limit switch positioning (Refer fig 4)
4. Damaged Limit switches (Refer fig 5)
5. Loose wiring connections (Refer fig 6)
6. Incorrect programming settings (Refer fig 7)
Step-by-Step Troubleshooting
*If you are uncomfortable or unsure about performing any of these tests please contact Richmond Wheel & Castor for
further support.
1. Check your post bracket mounting positions and critical distances in the chart below
- These measurements are critical for correct movement and is a common cause of movement issues
- Remove the arm from the gate and operate to see if the arm extends and retracts correctly
Fig 1
Fig 2
To Next Page
General
