HOW TO ASSEMBLE & OPERATE
YOUR CENTRIFUGAL JUICER
Place the food processor bowl on
F i x t h e J u i c e r N e t i n t h e
Put the Centrifugal bowl on the
Run the food processor on whip
position for a second to see if it
is fitted fine. You may now run
Introduce the vegetable/fruit to
be juiced through the feeder tube
and push down with the juicer
pusher. The juice will collect in
the bowl w hereas t he pulp
accumulates in the juicer body
along with the walls of the
strainer. After sufficient pulp
the grinder unit.
juicer cover.
has been collected, stop the juicer,
remove the pulp and restart the
juicer again.
1.
2.
3.
4.
5.
CIRCUIT BREAKER
(OVERLOAD RELAY FOR MOTOR PROTECTION)
WHIPPER / PULSE TECHNIQUE / INCHER
Operations like chopping & mincing sometimes need better consistency. To
agitate the food that is being processed in the food processor processing is
done in short bursts in lieu off continuous motion. This is achieved by
using the whipper speed by switching the machine on/off, this technique is
known as pulse technique.
We have provided a Circuit Breaker (CB) in
Many times, without realising, people tend to
overload the food processor, by putting more
material in the jar than recommended. This
results in the motor getting overloaded and
eventually burning out. In order to protect
your food processor from burning out, we
have provided a special overload relay known
This circuit breaker works just like the
In case, unintentionally, you overload the
machine and try to run it, the circuit breaker
will trip automatically, clearly cutting off the
electric supply, to the motor and switching off
the food processor, thereby protecting the
In case this event occurs, switch off the
machine, and allow the machine to cool for
2-3 minutes. Also reduce the material in the jar.
After 2-3 minutes, press in the button of the
Circuit Breaker (which is at the bottom of the
machine). Now switch on and restart the
your food processor.
as a circuit breaker.
common fuse in your house.
motor.
machine.
In this way, the Circuit Breaker protects your motor from burning out and
saves you from incurring any repairing cost.
CIRCUIT BRAKER
RED-TIP
PIN-ROD
NORMAL POSITION
PIN-ROD
HAS COME OUT
EXECESSIVE
CUT OFF
POSITION
PUSH
PIN-ROD
UPWARD
TO RE-SET
12 13
Centrifugal Juicer bowl.
drvie shaft.
To Next Page
Loading...