Ricoh SG Series User Manual

1
About SG Series Firmware Updates
(Web Image Monitor)
TABLE OF CONTENTS
1. About Firmware Updates .........................................................................2
2. Operating Environment ............................................................................ 2
3. Disclaimer ..................................................................................................2
4. Caution ........................................................................................................2
5. Firmware Update Operating Instructions ...............................................3
6. Wireless LAN Update Operating Instructions .....................................10
7. Trademarks ..............................................................................................21

Ricoh SG Series Specifications

General

Paper Input Capacity	250 sheets
Connectivity	Ethernet
Duplex Printing	Automatic
Color Output	Color
Media Types	Plain paper, envelopes, labels
Operating System Compatibility	Windows

Summary

Document Introduction and Prerequisites

About Firmware Updates

Manual explains software update process for SG series network boards.

Operating Environment

Web browser required for updates; TCP/IP protocols must be specified.

Disclaimer and Caution

Manufacturer not liable for damages; specifies firmware version prerequisites.

SG Series Firmware Update Procedure

Access Web Interface

Open a web browser and navigate to the machine's IP address or hostname.

Administrator Login

Enter username 'admin' and password (if set) to access device administration.

Navigate to ROM Update

Go to Settings > Device Settings > ROM Update in the web interface.

Select and Upload Firmware File

Use 'Browse' to select the firmware file and click 'Update' to begin.

Confirm Firmware Update

Click 'OK' after device reboot and check the firmware version for success.

Wireless LAN Firmware Update

Access Wireless LAN Settings

Log in and navigate to Settings > Device Settings > Wireless LAN Settings.

Specify Wireless LAN Firmware

In Wireless LAN Settings, use 'Browse' to select the firmware file.

Initiate Wireless LAN Update

Click 'Update' to start the wireless LAN firmware transfer and installation.

Verify Wireless LAN Update

Check the 'Wireless LAN' version in 'Device Info' after reboot for confirmation.

Trademarks Information