15
The next time the mode button is pressed and held, the last selected
plug-in is run. If a plug-in has never been run, the plug-in selection screen
appears.
In addition to the pre-installed plug-ins, you can add new plug-ins. When
the connection is established in the client mode, you can install plug-ins
on the plug-in selection screen.
For details on the plug-in, refer to the user guide.
https://support.theta360.com/en/manual/
Extending the Functions
You can use the camera in special modes by using the plug-
ins installed in the camera.
Running and Terminating the Plug‑in
1
Swipe left on the LCD panel to display the plug‑in
selection screen.
2
Tap the plug‑in to use.
The plug-in is run.
3
Press and hold the mode button on the side to
terminate the plug‑in.
Receptor4.0_QSG.indb 15 2021/09/06 14:13:34
To Next Page
Loading...
