Pull tapered end of film across back of camera and insert into and through
the left side of slit of Take-up Spool (CC). Rotate Take-up Spool in
direction of arrow to take film slack...check to see that sprocket holes in
film have engaged both sets of Sprocket Teeth (BB). (Fig. 1)4www.butkus.org
Close the camera back and snap it shut. Advance Film-wind Lever A)
twice, depressing Shutter Release Button (C) each time. Advance Film-
wind Lever once more and Film Counter (B) will be automatically set to
"1" ", ready for your first picture.
Set exposure meter for the film you are using, rotating Film Speed Selector
(G), while pulling it, until the ASA number of your film is opposite the
green indicator line. (Fig. 2) Also turn Film Reference Dial (0) and set the
corresponding type of your film to the black indicator line. This will help
to remind you of the type of the film you are using. Check the instruction
sheet packaged with your film for the correct ASA speed for that film.
If you are using German film, please refer to Fig. 3 for the relationship
between ASA and DIN.
Fig 3.
To Next Page
Loading...
Need help?
General
