Why are too many strokes needed to set a rivet with RidgeGate Tools?
If too many strokes are required to set a rivet, the likely cause is using the wrong nosepiece. Ensure that you choose the correct nosepiece.
What to do if rivet nuts or rivet studs could not be secure onto the mandrels in RidgeGate Tools?
If rivet nuts or rivet studs cannot be secured onto the mandrels, there are a couple of potential reasons: 1. A mandrel from a different standard might be used. Make sure to choose the correct mandrel. 2. The threads on the mandrel might be worn out. If this is the case, replace the mandrels.
What to do if the rivet stem did not come out of RidgeGate Tools?
If the rivet stem doesn't come out, the handle is likely not opened. Ensure you open the handles.
Why does it require too many strokes to set rivet nuts using RidgeGate AVAK MaxDuty Flex Tools?
If it requires too many strokes to set rivet nuts, the fixing screw nut might not be adjusted properly. Adjust the fixing screw nut accordingly.
Kits for adding functionality to the tool.
Sets for expanding mandrel capabilities.
Important safety instructions and precautions for tool operation.
Instructions for fastening rivets using the tool.
Procedure for cleaning and replacing jaws.
Guide to diagnose and resolve common operational issues.
To Next Page
General