RIDGID D Series - Step 1: Prepare Bumper Brace; Step 2: Install Fog Light Bracket

FIGURE 1
FIGURE 1.1
FIGURE 2
STEP 1
Remove the 8mm head bolt on the
bumper brace and on the bumper
side, while simply loosening the bolt
on the other end of the brace to allow
it to dangle.
See Figures 1 & 1.1
STEP 2
Install the RIGID fog light bracket as
shown. Using the provided hardware,
install the M6 bolt and washer
through the bumper brace.
See Figure 2
Remove Bolt
Loosen Bolt