RIDGID RB32 - User Manual

To Next Page

For Models RB48 and RB60:

• Do NOT put fuels, ammables, explosives or hazardous

materials inside these products.

• Gasoline, solvents, gun powder or other munitions,

dynamite, propane, acetylene or other such products can

explode if stored inside these products.

• Use these products ONLY for storing and transporting

electric or hand tools and equipment, and other similar

materials.

• Failure to follow these warnings or modications or other

uses of these products could result in death, serious injury

or property damage.

OPERATORS MANUAL

MODELS RB32, RB48, RB60

RIDGID ON-SITE STORAGE EQUIPMENT

DANGER

–NOTICE–

Keep hands clear when closing lid. Failure to do so could result in severe injury.

WARNING

Read and understand all instructions and warnings before operating or using this product.

–ATTENTION–

To prevent electric shock, explosion, re and/or serious

personal injury when using storage chest with:

Extension Cord -

• Follow all Extension Cord manufacturer’s Warnings

and Instructions.

• After removing knock-out, insert RAPID PASS

rubber

grommet. Do NOT insert extension cord through hole

without grommet in place (see gure 8, on page 3).

• Only use a three-wire extension cord with all three prongs

intact. Never remove the round grounding prong.

• Extension cord must be connected to a 120 Volt GFCI

protected outlet with proper ground. If GFCI outlet is

not available, use an extension cord with GFCI protection

built in.

• Check the insulation and plugs of extension cord before

using. Do NOT use cord if it is worn or damaged.

• Do NOT overload extension cord.

• Remove extension cord from the RAPID PASS

hole before

moving or transporting storage chest.

• Only use an extension cord that is rated for outdoor use.

• Do NOT connect extension cord to outlet that also supplies

critical safety equipment with power.

Cordless Power Tool Battery Chargers -

• See Charger’s Owner’s Manual for proper use and care of

charger and batteries. Follow all Warnings and Instructions

provided with your battery charger.

• Place chargers and electrical connections in tray.

• Chargers are Dry location use only. Do NOT expose to

liquid, vapor, or rain. Should your charger become wet, Do

NOT attempt to use. Unplug extension cord from supply

before handling wet charger or cords.

• Only use chargers and batteries that are intact and

operating properly.

• Do NOT touch metal prongs when plugging charger into

extension cord.

• Keep ammable materials like paper or rags away from

charger, cords or connections.

• Do NOT place or attempt to charge lead acid, car type

batteries in storage chest.

WARNING

Any modication or unintended use of this product shall

immediately void all manufacturers warranties. Manufacturer

disclaims all liability for injuries to persons or property result-

ing from any modication to, or unintended use of this product.

Main Page

Need help?

Do you have a question about the RIDGID RB32 and is the answer not in the manual?

This document is an operator's manual for RIDGID On-Site Storage Equipment, specifically models RB32, RB48, and RB60. It provides essential information regarding the safe operation, installation, and maintenance of these storage chests.

Function Description:

The RIDGID On-Site Storage Equipment is designed for storing and transporting electric or hand tools and equipment, and other similar materials. It is explicitly stated that these products are ONLY for this purpose and should NOT be used for storing fuels, flammables, explosives, or hazardous materials. The manual strongly warns against storing items like gasoline, solvents, gunpowder, munitions, dynamite, propane, or acetylene, as they can explode. Failure to adhere to these warnings can result in death, serious injury, or property damage.

Important Technical Specifications:

While the manual does not list detailed technical specifications like dimensions or weight, it provides crucial information regarding accessories and replacement parts.

Padlock Information: The chests are designed for use with padlocks having a shackle height of 7/8" to 1" (22.2 to 25.4 mm). A Master No. 5 padlock or equivalent is recommended (not included).
RAPID PASS® Grommet (Models RB48 and RB60): These models feature a RAPID PASS® rubber grommet (part number 7628) for safely routing extension cords into the chest. This grommet ensures that no sharp metal edges are exposed, preventing damage to the cord.
Extension Cord Requirements (Models RB48 and RB60):
- Only three-wire extension cords with all three prongs intact should be used.
- The round grounding prong must never be removed.
- The extension cord must be connected to a 120 Volt GFCI protected outlet with proper ground. If a GFCI outlet is unavailable, an extension cord with built-in GFCI protection should be used.
- The cord's insulation and plugs must be checked for wear or damage before use.
- The extension cord must be rated for outdoor use.
- The extension cord should NOT be connected to an outlet that also supplies critical safety equipment with power.
Cordless Power Tool Battery Chargers (Models RB48 and RB60):
- Chargers are for dry location use only and must not be exposed to liquid, vapor, or rain.
- Only intact and properly operating chargers and batteries should be used.
- Flammable materials should be kept away from chargers, cords, and connections.
- Lead-acid, car-type batteries should NOT be placed or charged in the storage chest.

Usage Features:

The manual details several usage features to ensure safe and proper operation:

Padlock Installation: Instructions are provided for installing padlocks. This involves sliding a U-bolt over the padlock shackle, inserting the lock through the lock housing, guiding the U-bolt through holes in the back of the housing, and securing it with nylon lock nuts. To lock, the lid is closed, and the padlock is pushed until it "clicks" closed. To open, the key is turned, and the lid is opened.
RAPID PASS® Grommet Installation (Models RB48 and RB60): This feature allows for the safe passage of extension cords into the storage chest. Installation involves punching out a knockout from the inside of the rear box panel and then placing the rubber RAPID PASS® grommet into the hole, ensuring it is properly seated and no sharp metal edges are exposed. When passing cords, they must always enter from the rear, and after the cord head is in place, it should be pulled back 2-3 inches to ensure the weather-resistant "star bursts" face the outside of the box. Cords should never be pushed from the inside, which would expose mating plug points to the environment.
Safety Warnings: The manual emphasizes keeping hands clear when closing the lid to prevent severe injury. It also reiterates the importance of reading and understanding all instructions and warnings before operating or using the product.

Maintenance Features:

The manual includes instructions for specific maintenance tasks and general care:

Dampening Spring Removal: Instructions are provided for removing the dampening springs, which likely assist in lid operation. This involves ensuring the cover support is locked, then using a small screwdriver to pry up the spring clip until the ball stud is released, allowing the spring to be pulled away. This process is repeated for both the top and bottom clips.
Extension Cord Inspection: Users are instructed to check the insulation and plugs of extension cords before each use and to NOT use a cord if it is worn or damaged.
Charger and Battery Care: Users are directed to consult the charger's owner's manual for proper use and care of chargers and batteries.
Replacement Parts: A list of available replacement parts is provided, including:
- U-Bolt & Nylon Lock Nut Hardware Kit (part number 7357) for RB32, RB48, RB60 models.
- RAPID PASS® Rubber Grommet (part number 7628) for RB48, RB60 models.
- Dampening Spring (part number 70982) for RB48, RB60 models.
- It is explicitly stated that no other replacement parts are available for these models.
Warranty Information: The product comes with a three-year limited warranty from the date of purchase, covering defects in material and workmanship. Any modification or unintended use of the product immediately voids all manufacturer warranties, and the manufacturer disclaims all liability for injuries or property damage resulting from such actions. For warranty claims or questions, customers are advised to contact RIDGID On-Site Storage Equipment at 1-800-4-RIDGID (1-800-474-3443).

RIDGID RB32 Specifications

General

Brand	RIDGID
Model	RB32
Category	Storage
Language	English