Riello RPS 25/4 - General Information; Table of Contents; General Safety Information

2
GENERAL INFORMATION
This manual, Code 20134586 - Rev. 1 (10/2017)
comprises 16 pages.
GENERAL INFORMATION
RANGE
MODEL CODE
RPS 25/4 20127137
RPS 25/4 (2 pcs. pack.) 20127139
RPS 25/4 (5 pcs. pack.) 20127140
ACCESSORIES
For a complete list of accessories and details of their compatibil-
ity, refer to the Catalogue.
Dear heating engineer,
We would like to congratulate you on having recommended a
R Solar collector unit: a modern product that's capable of
ensuring a high degree of reliability, efciency, quality and safe-
ty.
This booklet pr
ovides the information necessary for a correct
and simple installation of the system, whatever your expertise
and technical competence.
Thank you again, and keep up the good work,
Riello S.p.A.
CONTENTS
The following symbols are used in this manual:
9
CAUTION! = Identies actions that require caution and
adequate preparation.
0
STOP! = Identies actions that you MUST NOT do.
CONFORMITY
Solar collectors comply with EN 12975-1, ISO 9806 and Solar Key-
mark certication.
1 GENERAL SAFETY INFORMATION
9
Check that the product is complete, undamaged and as or-
dered as soon as you receive it. Report any discrepancies or
damage to the
R dealer who sold it.
9
This product must be installed by a legally qualied heat-
ing engineer. On completion of the installation, the install-
er must issue the owner with a declaration of conformity
conrming that the installation has been completed to the
highest standards in compliance with the instructions pro-
vided by
R in this instruction manual, and that it con-
forms to all applicable laws and standards.
9
This product must only be used for the purpose for which it
is designed and made, as specied by
R. R declines
all responsibility, contractual or other, for damage to prop-
erty or injury to persons or animals caused by improper in-
stallation, adjustment, maintenance or use.
9
All servicing and repairs must be performed by a qualied
heating engineer.
9
Solar collectors must be installed with the correct mounting
kit (which includes all necessary rails and brackets) as listed
in the Catalogue.
9
A protective lm is applied to the glass of the solar collector
to protect the absorber against solar irradiation and prevent
the solar collector from becoming too hot if it is not going
to be put into service immediately. Fill the system, but do
not remove the lm until you are ready to put the system
into service. Take care when removing the lm as it may be
electrostatically charged. Do not leave the protective lm in
place for longer than 12 months. Once removed, the pro-
tective lm cannot be re-used. Dispose of the protective
lm in compliance with legislation governing the disposal
of PVC.
This manual, Code
- Rev.
comprises
pages.
ENGLISH
General information
GENERAL INFORMATION
1 General Safety Information ......................2
2 Precautions..................................3
3 Description of the appliance .....................4
4 Identication ................................4
5 System layout ................................5
6 Technical specications.........................5
INSTALLATION
7 Unpacking the product .........................7
8 Handling....................................7
9 Installation area ..............................8
10 Installation on at roofs with ballast...............9
11 Water connections ........................... 10
12 Source water system .......................... 12
13 Filling and emptying.......................... 13
14 Device cleaning and maintenance ............... 13
15 Recycling and disposal ........................ 13
END USER
16 External maintenance......................... 14