Rigel MULTI-FLO User Manual

How do I use Multi-Flo in Remote
Control mode on Med-eBase?
To use the remote control mode the user will need to install the Gadget
Serial V2.4 Driver. The Gadget serial driver is available at rigelmedical.com in
the download section. To install the gadget serial driver the Multi-Flo needs
to be turned on and connected to the PC using the USB serial cable.
Equipment required:
- Multi-Flo
- PC running Med-eBase V2.4 or higher
- Gadget serial driver install files
- USB Serial cable or memory stick
1) On the Multi-Flo menu scroll down and select remote control mode. The
Multi-Flo will then try to connect with the PC.
2) The PC will attempt to download the install drivers for the gadget serial.
As the driver is located on the PC and cannot be found on the internet this
step is not required. Click on the icon when it appears as seen below.
3) Select “skip obtaining driver software” which is blue and underlined to
stop widows looking for driver as the Rigel device won’t be able to connect
to the PC while the computer is performing this task. Select yes on the
driver software installation screen to skip the driver update.

Rigel MULTI-FLO Specifications

General

Dimensions	210 x 120 x 80 mm (8.3 x 4.7 x 3.1 in)
Weight	1.2 kg (2.6 lbs)
Type	Infusion Pump
Connectivity	USB
Display	LCD
Power Supply	Rechargeable battery or AC adapter
Channels	Single Channel
Operating Temperature	15 to 35°C (59 to 95°F)
Storage Temperature	-20 to 50°C (-4 to 122°F)

Summary

Using Multi-Flo in Remote Control Mode on Med-eBase

Initial Setup and Connection

Install the Gadget Serial V2.4 Driver and connect the Multi-Flo to the PC via USB serial cable.

Start Remote Control Mode

On the Multi-Flo, scroll to and select remote control mode to initiate PC connection.

Skip Driver Update

Select 'skip obtaining driver software' and confirm to prevent driver update interference.

Configure Gadget Serial Driver

Access Control Panel, update driver by browsing for files in the correct folder.

Verify Installation and Download

Confirm driver installation and download data from the Multi-Flo via Med-eBase.