To Next PageTo Next PageWhat to do if Rigid Industries Portable Generator AC receptacle does not work?
If the AC receptacle on your Rigid Industries Portable Generator isn't working, check if the circuit breaker is OFF and turn it ON. Also, reset the GFCI. Finally, test the receptacle with a different item to rule out a defective item.
Why Rigid Industries Portable Generator engine will not start?
Your Rigid Industries Portable Generator might fail to start due to several reasons: there's no fuel, the gasoline is stale or contaminated with water, the lubricant level is low (the engine is equipped with Low Oil Shutoff), the fuel valve is OFF, the spark plug is faulty, fouled, or improperly gapped, the choke lever is in RUN position, the engine was stored without treating or draining gasoline, or the fuel filter is dirty. To resolve this, fill the fuel tank, drain the fuel system and refill with fresh fuel, check and replenish the engine lubricant, turn the fuel valve ON, replace the spark plug, move the choke lever to the START position, and replace the fuel filter.
Why does my Rigid Industries Portable Generator make a “spark knock” or “pinging” noise?
An occasional light knocking or pinging under a heavy load is usually not a cause for concern. However, if your Rigid Industries Portable Generator consistently knocks or pings under normal load at a steady engine speed, try switching to a different brand of gasoline with an octane rating of 86 or higher.
General| Brand | Rigid Industries |
|---|---|
| Model | RD903612 |
| Category | Portable Generator |
| Language | English |
Generator exhaust contains high levels of carbon monoxide (CO), a poisonous gas.
Generator must be installed by electrician for building wiring systems.
Table to determine appropriate extension cord size for load capacity.
Estimates starting watts required for electric motors based on HP.
Explains GFCI protection, testing, and reset procedures for receptacles.
Crucial for safe operation and understanding power needs.
Sequential steps for adding electrical loads to the generator safely.
Details engine type, fuel/oil volume, generator voltage/amps, dimensions, weight.
Describes key parts like AC breaker, air filter, choke, engine switch, fuel system.
Includes ground terminal, oil check, drain plug, receptacles, and smart display.
Instructions for removing the product and checking contents.
List of included items for assembly.
Lists required tools for assembly.
Step-by-step guide for attaching the generator legs.
Instructions for attaching the wheels to the generator.
Describes the intended use of the generator for electrical power.
Guidelines for safe operation setup, including location and surface.
Information on regulations, registration, and construction site use.
Covers handle adjustment, fuel/oil checks, and fuel stabilizer use.
Details the Smart Display and Hour Meter functions.
Covers moving, lifting, starting, and stopping the generator.
Details maintenance alerts and high altitude operation.
Covers general cleaning and air filter maintenance.
Details lubricant change, spark plug, and exhaust port cleaning.
Covers spark arrestor, fuel draining, and fuel filter replacement.
Guidelines for transport and legal warnings.
Guidelines for preparing the generator for storage.
Table outlining required maintenance tasks and intervals.
Covers the 3-year limited warranty, what is and isn't covered, and engine warranty.
Provides guidance on obtaining service and additional limitations.
Details the warranty specific to the Subaru Robin engine.
Lists conditions and usage that void the engine warranty.
Details federal emission control system warranty and owner responsibilities.
Covers defects, part failures, and claim procedures.
