Chapter 2 Functions of the Front Panel RIGOL
VNA User Guide 2-55
⚫ Executes the factory resetting operation.
Language
RSA supports multi-language menu, Chinese and English built-in help and pop-up
messages.
Press this key to select the desired display language.
Settings
1. Power Switch
Sets whether the power switch on the front panel is effective or not.
⚫ Default: When the analyzer is powered on, press the power switch on the
front panel to start up the analyzer.
⚫ Always: When the analyzer is powered on, it starts automatically.
2. Beep Switch
Turns on or off the beeper. By default, it is Off.
3. Volume
After you turn on the beeper, you can press this key to adjust the volume of the
beeper.
4. User Key
Defines an associated function for the User key on the front panel. The
definition method is as described below. After that, pressing User in any
operation interface can quickly enable the defined function.
⚫ Press User Key to select "On";
⚫ Open the function menu that needs to be defined. For example, press
System → Display → LCD Backlight;
⚫ Press User and the definition is finished. At this time, User Key turns off
automatically.
5. SCPI Display
When you use the SCPI commands to control the instrument remotely, turning
on the SCPI Display will go to the specified menu of the corresponding
command; turning off the SCPI Display will not go to the specified menu.
Messages
Press this key, and then a prompt message dialog box will be displayed. You can
press the corresponding softkey to select to view all the messages, the messages
To Next Page
Loading...
