Note
[1]
: Not affected by Preset settings.
User
User-defined shortcut key. For some hard-to-find but commonly used function menu,
you can define it as shortcut key (for the defining method, refer to the introduction in
"User Key"). After that, press the shortcut key under any operation interface to
quickly open and set the desired menu or function.
Note: You can use the User key to define all the keys on the front panel and the
sub-menus of these keys (except Save).
Quick Save
Repeats the most recent save that was performed from the Save menu. Its saving
path is the currently defined "quick save path".
Cont
Press this key to perform the continuous sweep operation.
Single
Press this key to perform the single sweep operation.
System Function
System
Sets the system parameters.
To Next Page
Loading...
