Installing batteries
Open the battery compartment of the receiver and insert two“AAA”batterries with correct polarity.
Open the battery compartment of the transmitter and insert two“AAA”batterries with correct polarity.
Turn On/Off Unit
Press and hold for 2 seconds button on the receiver to turn on/off the receiver.
Press button on the transmitter to turn on/off the transmitter.
Synchronize/Pair Transmitter and Receiver
The transmitter and receiver were already paired at our manufacturing facility. Usually you do not
need to re-synchronize or re-pair the units. You just plug in the probes, insert batteries, turn on the
receiver and the transmitter and wait for a few seconds. You will see the temperatures shown on
both receiver and transmitter and the units are ready for use.
However, in some unusual cases, the transmitter and receiver are no longer paired, then you may
need to re-synchronize them by following the below steps:
a. insert the stainless steel probes into the corresponding plugs in the transmitter.
F C
b. Turn on the transmitter by pressing the button. The transmitter will show the current
temperatures on it’s LCD display.
c. Turn on the receiver by pressing the button.
d. Press and hold Mode button on receiver for 2~3 seconds to enter the synchronization mode
which will last for 60 seconds. The display shows“---”and it is flashing.
e. Wait for a moment until the temperature reading shows on the receiver display, it means the
synchronization/Pairing is complete. Your professional remote cooking thermometer is now ready
for use.
Note: The synchronization between the transmitter and the receiver won't be lost even if you
replace the batteries.
Loss link alert
I
the transmitter, the receiver may not be able to receive the transmission from the transmitter, The
receiving unit will beep every 5 minutes to remind you of the signal loss.
To regain transmission signal, move the receiver closer to the transmitter, the link should be
automatically restored and the temperatures should appear on the receiver display.
f the receiver is taken out of range or there is abnormal external interference or after shutting off
F C
To Next Page
Loading...