Rikon Power Tools 80-808

Questions and Answers

M
Matthew DavisJul 27, 2025
What to do if fuses blow in Rikon Power Tools 80-808?
- E
  Erika RodgersJul 27, 2025
  If the fuses blow or the circuit breaker trips on your Rikon Power Tools Grinder, there are several potential causes: * The motor may be overloaded, in which case you should reduce pressure on the workpiece. * The electrical circuit could be overloaded; try reducing the number of items on the circuit. * The fuse or circuit breaker might be undersized; replace it with the correct size. * A defective cord, plug, or switch could be creating a short circuit, requiring replacement with new parts. * An undersized or excessively long extension cord could be the issue; use the correct size and length. * Material may be wedged between the wheel and the tool rest or guard; turn off the grinder, unplug it, and remove the material.
W
William BurkeAug 2, 2025
Why does my Rikon Power Tools Grinder motor not run?
- R
  Richard WoodAug 2, 2025
  If the motor on your Rikon Power Tools Grinder isn't running, consider these possible causes: 1. The machine might not be plugged in. Ensure the power cord is securely plugged into an electrical receptacle. 2. The power switch may be in the “OFF” position. Lift the switch to the “ON” position. 3. The power switch or cord could be faulty. Replace the switch or power cord. 4. A fuse or circuit breaker may be open due to an overloaded electrical circuit. 5. Material might be wedged between the wheel and the tool rest or guard. Turn the grinder off, unplug the power cord, and remove the material.
N
Nathaniel BuchananAug 8, 2025
What to do if Rikon Power Tools 80-808 Grinder motor stalls?
- K
  Kyle FarleyAug 8, 2025
  If your Rikon Power Tools Grinder motor stalls or runs slowly, it could be due to a few reasons: * The motor might be overloaded. Try reducing the pressure on the workpiece. * There could be incorrect line voltage. Have a qualified electrician check the circuit for proper voltage. * The motor capacitor may have failed. If so, replace the motor capacitor.
K
Kevin JenkinsAug 13, 2025
Why does my Rikon Power Tools Grinder motor run hot?
- J
  James MorrisAug 14, 2025
  If the motor of your Rikon Power Tools Grinder is running hot, it could be due to: * The motor is overloaded: Reduce pressure on the workpiece. * Poor air circulation around the motor: Remove any blockage around the motor. * Overuse in a high ambient temperature room: Reduce runtime to 20 minutes or less.
J
Joseph BarrAug 20, 2025
How to fix Rikon Power Tools 80-808 Grinder motor with no full power?
- D
  Daryl CollinsAug 20, 2025
  If your Rikon Power Tools Grinder motor lacks full power, consider these possibilities: * Incorrect line voltage could be the issue. Have a qualified electrician check the circuit for proper voltage. * The motor capacitor may have failed, requiring replacement.