Technical Procedure
Date 01/09/04
Installing a Prism Printer Ribbon
We recommend you store all ribbons at a temperature between 60°–95°F, and avoid moisture
or direct sunlight. If you are replacing the ribbon, now is a good time to clean the printhead.
Procedure
1. Power on the printer.
2. Remove the top cover.
3. Pull up the Take-up Roller so the end with the gear comes up first as shown
below, and remove the Take-up Roller out of the printer.
4. Remove the Supply Roller by pulling up on the end as shown.
InstallingPrismRibbon.doc 1 of 5
To Next Page
Need help?
General
