PowerSourcePro
User Manual
RINV1000
RINV2000
4
L209
Protective features
Low battery alarm - An alarm will sound when the voltage from the battery drops to 10.5 volts DC. This indicates
that the battery the PowerSource is connected to will require recharging. (If connected to a vehicle battery,
starting the vehicle engine should be sufficient) The Powersource will automatically shutdown if its voltage is
allowed to drop to 9.5 volts DC or below.
Over voltage protection - The PowerSource will automatically shutdown if the input voltage exceeds 15 volts DC.
Reverse polarity protection - Reverse polarity (incorrect battery connection) may result in the blowing of the
internal blade fuses. If this occurs immediately, disconnect the battery.The internal blade fuses will need to be
checked by a qualified electrician if the PowerSource does not continue to work.
Overload protection - The PowerSource will automatically shut down if the continuous power draw exceeds its
maximum rating of the PowerSource.
Temperature protection - If the temperature of the internal heat sink reaches >65oC the Powersource will shut
down automatically. Allow the PowerSource to cool before using again.
Troubleshooting guide
Problem Possible Cause Suggested Remedy
Low output voltage PowerSource is overloaded Reduce load, not exceeding maximum rating
Low battery alarm on all the time Inadequate power or excessive voltage drop Check connections from battery
to PowerSource
Poor battery condition Replace battery
No Power output PowerSource not fully warmed up Turn the PowerSource switch on and off
repeatedly until the appliance has started.
Internal fuses have blown Fuse replacement (qualified electrician only)
PowerSource in thermal shutdown condition Allow to cool (10 Minutes)
Low battery voltage Charge or replace battery
Specifications
PowerSource Model RINV1000 RINV2000
Max. Continuous power (Watts)
1
/
2
hour only 1000w 2000w
Continuous Power 800w 1600w
Peak Power (Watts) 0.01 Seconds 2000w 4000w
Standby current (AMPS) < 0.5A < 0.8A
Waveform Modified sine wave Modified sine wave
Efficiency Ω Approximately 90 % Approximately 90 %
Input Voltage Range 10v – 15v DC 10v – 15v DC
AC Socket 3 Pin mains 3 Pin mains
Fuse 30 amps (x 4) 30 amps (x 8)
Ω Percentage of battery power converted to mains voltage power.
‘e’& ‘CE’ approved
Distributed by:
Ring Automotive Gelderd Road, Leeds LS12 6NB
Tel: +44 (0)113 276 7676 Fax: +44 (0)113 231 0266
Email: autosales@ring.ltd.uk
To Next Page
Need help?
General