PowerSource
Mains powered equipment from a 12v source
User Manual
12v DC to 230-240v AC Power Source
500 Watts
Model
RINV500
Distributed by:
Ring Automotive Gelderd Road, Leeds LS12 6NB
Tel: +44 (0)113 276 7676 Fax: +44 (0)113 231 0266
Email: autosales@ring.ltd.uk
4
Specifications
PowerSource Model RINV500
Max. Continuous power (Watts) 500w (1/2 hour) 400w (4hrs)
Peak Power (Watts) 0.01 Seconds 800w
No load current draw (AMPS) <0.2A
Waveform Modified Sine
Cable length 1m
Cable diameter 7mm
Efficiency* Approximately 90%
Input Voltage Range 10 – 15v DC
AC Socket 3 Pin Mains (BS Approved)
Fuse 35 amps (x2)
Weight (kgs)** 1.5
Dimensions (mm) 230 x 107 x 60
* Percentage of battery power converted to mains voltage power. ** Does not include packaging
Troubleshooting Guide
Symptom
AC appliance will not operate;
the audible alarm is sounding.
AC applianc
e will not operate;
the audible alarm is not
sounding.
Run time is less than expected
Possible causes
1. Battery has discharged to 10v.
2.The inverter has overheated. This
could be due to poor ventilation.
3. Poor battery condition
1. In
verter is overloaded.
2. Internal fuses have blown
1. Battery is not fully charged
2. AC appliance power
consumption is higher than
expected.
Possible solution
Turn off the inverter on/off switch
and recharge the battery.
Turn off the inverter and allow to
cool for 10 mins.
Replace battery.
Reduce load, not exceeding
maximum rating.
Fuse replacement (qualified
electrician only)
Recharge the battery.
Check AC appliance wattage
rating is within scope of inverter.
CE and e approved. L209
For further assistance:Technical Helpline: +44 (0)113 276 7244
To Next Page
Need help?
General