ring AutoTester RMM500 - Page 12

12
5.7.1 Pulse Count Mode
1. Turn Selector Dial to Frequency (Hz posion)
2. Select Pulse Count Mode then press
buon to connue
3. Connect probes to circuit to be tested red=posive(+), black=negave(-)
4. Display will show the frequency of pulses in the circuit under test.
5. Press exit buon
to return to Main Menu
5.7.2 Duty Cycle Mode
1. Turn Selector Dial to Frequency (Hz posion)
2. Select Duty Cycle Mode then press
buon to connue
3. Connect probes to circuit to be tested red=posive(+), black=negave(-)
4. Display will show the duty cycle of pulses in the circuit under test.
5. Press exit buon
to return to Main Menu
5.8 Connuity Test
1. Turn Selector Dial to Connuity (
posion)
2. Connect probes to either end of circuit to be measured
3. Beeper will sound if connuity is detected
Peak to Peak Voltage
during test
No measurement
No measurement
Example frequency
Example Duty Cycle
GB
10422 RMM500 Instructions UK 140x170mm 15pp MULTI LANGUAGE.indb 12 23/08/2017 17:13