ring Flood - Installing and Placing Your Flood;Freeze Sensor; Testing Sensor Connectivity

Test your Flood/Free1e Sensor.
Now that your Sensor is set up, bring it to
the area you want to monitor. To ensure
it remains connected to your Alarm Base
Station in its new location, test the Sensor.
To do this, push the Setup button inside
the Sensor. If the LED blinks blue, the
Sensor is connected and ready to place.
If it blinks red, try the test again. You may
find that repositioning the Sensor (even
just a few inches) can improve reception.
0
If the Sensor cannot connect
1
try installing a
Ring Range Extender between your Sensor
and Base Station.