One sensor wire/two plastic supports/one usermaual
Load Normal Sensor Power
Close
Installation notes:
1
.Before use, please carefully read the user manual, must distinguish the functions of the different
contact points. The connected load power should not exceed the capacity of contact point (if
exceeding, please connect AC contactor). Each connecting wire should be connected to the
terminals firmly.
2.Please install the device firmly in a stable place, avoid crash. The device cannot be placed with
dripping or water, and keep away from the electromagnetic interference of the electrical apparatus.
3.In order to prevent the interference of high frequency, the sensors and low voltage lines cannot
parallel and be bundled up with high voltage line. The diameter of the high voltage wire must be
between 0.75 mm and 1.5mm.
4.If the device is disturbed, please cut off the power, and restart. This software belongs to class A,
which is not applicable to safety protection control.
5.Do not privately disassemble the device. If faults occur or have questions of the usage, please
contact our company.
To Previous Page
Loading...
