You Will Need
• Module (supplied)
• Two wall anchors and two screws (supplied)
IMPORTANT: The anchors and screws are for mounting
to the wall; do not insert them into the tankless water
heater.
• Tools (field-supplied): Phillips head screwdriver, drill with
bit set, level and pencil
The module’s back panel contains two keyhole slots
that support the module. Mark the location of each
slot on the wall with a pencil. The distance between
the two slots is 1.9 in. (48 mm).
Use a level to ensure the slots are even.
Use a power drill to drill pilot holes for the module
screws and anchors.
1.9 in.
(48 mm)
❶
❷
AYLA
ID
To Next Page
Loading...