Rinnai 7 HW_CF_DELUXE OIM
Setting The Sound Options
To set the sound options press the Mode button once to place the controller into
‘Voice’ mode.
Use the or buttons to select one of the desired audible setting as follows:
Voice - High, Med, Low or O
Setting the voice prompt volume does not aect the audible tones.
Sound OFF, mutes all voice prompts and audible tones.
Press the Mode button twice to return to normal operation.
If no buttons are pressed for a period of approximately 10 seconds the
controller will return to normal operation�
Setting The Clock
The clock is a 12 hour AM/PM style display.
To set the time press the Mode button twice, this places the controller into clock
setting mode and in the digital monitor the word Clock will be displayed and the
clock digits will ash.
Use the or buttons to select the desired time, holding these buttons down
continuously cycles the digits.
When you get close to the time you wish to set, press the button intermittently to
avoid going further than the desired time.
To return to normal operation press the Mode button once.
If no buttons are pressed for a period of approximately 60 seconds the
controller will return to normal operation�
The time is always displayed regardless of whether the water controller
is turned ON or OFF�
The clock may need resetting if power to the water heater unit is
disrupted due to a power failure or if the power is switched o over a
prolonged period�
The default factory start time is set to AM 12:00�
Water Controller Combinations & Congurations
Wireless, Universal and Deluxe water controllers can be combined, Refer to "Water
Controller Combinations & Congurations" on page 5 to conrm the maximum
number and combination of controllers that can be tted.
WATER CONTROLLER OPERATION
To Next Page
Loading...
Need help?
General
