Facial Steamer (SUFA2)
Getting started
STEP 1 Ensure that your Facial Steamer is placed on a flat surface.
Pull the water chamber upwards to remove from the water inlet.
STEP 2 Unscrew the cap and fill the water chamber with 120ml of
water, ensure that the water level does not exceed this.
Note: The use of filtered or distilled water is recommended.
STEP 3 Firmly re-attach the cap and push the water chamber fully back
into the water inlet.
STEP 4 Remove any make up and rinse your face well.
How To Use
To Next Page
Loading...
