RIOTEC LS6300E User Manual (English)

Other manuals for RIOTEC LS6300E

Questions and Answers:

U
uhuntAug 9, 2025
Why is scanned data incorrectly displayed on the host with my RIOTEC Barcode Reader?
- V
  vjimenezAug 9, 2025
  Incorrect display of scanned data on the host with the RIOTEC Barcode Reader may occur if the proper host type isn't selected. For RS232, ensure that the scanner’s communication parameters match the host’s settings. For keyboard emulation configuration, ensure the system is programmed for the correct keyboard type, and that the CAPS LOCK key is off. Also, ensure editing options (e.g., UPC-E to UPC-A Conversion) are properly programmed. Another potential cause is a mismatch between the scanner’s Keyboard Country setting and the computer’s keyboard setup. To resolve this, set the scanner’s Keyboard Country to the same setting as the keyboard on your computer.
L
Lisa BallAug 14, 2025
What to do if the RIOTEC LS6300E Barcode Reader beeps, but no data is displayed on my computer?
- N
  Natalie LopezAug 14, 2025
  If your RIOTEC Barcode Reader beeps but no data is displayed on your computer, it might be due to an incorrect host type configuration. Ensure the scanner is configured to the appropriate host type by scanning the corresponding programming barcode in the User’s Manual. Another possible reason is that the scanner is configured to send numeric data as KEYPAD NUMERICS, or the Keyboard Country setting is set to UNIVERSAL. To fix this, reconfigure the scanner to send numerics as MAIN KEYBOARD KEYS and set the Keyboard Country setting to the country setting of your computer.
L
lopezrobinAug 19, 2025
Why does the RIOTEC LS6300E Barcode Reader light come on, but the symbol does not decode?
- L
  lyonsedgarAug 19, 2025
  If the light on your RIOTEC Barcode Reader comes on but the symbol does not decode, there could be several reasons. First, the scanner may not be programmed for the correct bar-code type. Refer to the User’s Guide to select the correct interface and ensure the scanner is programmed to read the type of barcode you are scanning. Second, the barcode symbol may be unreadable; check the symbol to ensure it is not defaced and try scanning test symbols of the same barcode type. Finally, the distance between the scanner and barcode might be incorrect; try moving the scanner closer to or further from the barcode.