10
All the cameras that are connected to the NVR’s LAN will be automatically
detected and displayed on the side panel.
8. Select the boxes of the IP Cameras to be added to the NVR.
NOTE: Only
the IP Cameras in the list that are enabled can be added. In rare cases,
when IP Cameras are on the same LAN and are connected to another site, they will
be displayed but not enabled.
Figure 8 Select Camera for NVR
9. Click Next. A Wizard will guide you through the settings of each of the
selected cameras. You can quit the Wizard at any stage.
The Wizard screens contain mostly read-only information. For each camera
you should select only the required recording mode.
To Next Page
Loading...
Need help?
General
