System Type Confirmation
This screen will only appear following the edit of system type.
If system type is to be edit again,
Pressing the “ up” key will scroll between “3“ for 3 phase
3 Wire and “4” for 3 Phase 4 Wire.
Pressing the “ down” key sets the displayed value and
will advance to “Potential Transformer Primary Value Edit”
menu. (See section 3.1.2 for 3V & V) and “Current
X1000
L1
L2
L3
V
X1000
L1
L2
L3
V
RMS
TRUE
transformer primary value (see section 3.1.3 for 3A & A)
3.1.2. Potential Transformer Primary Value (for 3V & V)
This screen displays “PtPr” message followed by previously set PT primary value on display.
For Eine 3V (3 phase) user can set PT primary value from 100VLL to 999kVLL & for
Eine V (single phase), user can set PT primary from 57.5(VLN) to 999 (kVLN).
Pressing the “ ” key accepts the present value and advances
to the “PT Secondary ” selection menu(See Section 3.1.4) for
Eine -3V and V.
Pressing the “ ” key will enter the “Potential transformer
Primary Value Multiplier Selection.
Eine 3V: Initially the “multiplier must be selected. Pressing
the “ ” Key will move the decimal point position to the sider ight
and show # # #. , after which it will again Shift to #.# #, # #.#,
Pressing the “ ” key accepts the present multiplier (Decimal Point position) and advances
to the “PT Primary value Edit” menu with decimal flashing to indicate cursor position.
# # #. with Annunciation of “x1000”, which indicates the value in kV.
X1000
L1
L2
L3
V
X1000
L1
L2
L3
V
RMS
TRUE
Eine -V: Initially the “multiplier must be selected. Pressing the “ ” Key will move the decimal
point position to the Sideright and show # # .# #, # # #.# after which it will again shift
to #.# # #, # #.# #, # # #.# With annunciation of “x1000”, which indicates the value in kV.
PT Primary value Edit
Pressing the “ ” key accepts the present value at the cursor position and advances the
Pressing the “ ” key will scroll the value of the most significant digit.
cursor to the next Less significant digit.When the least significant digit has been set,
6
To Next Page
Loading...
