4. Installation
Mounting of EINE is featured with easy “Clip- in” mounting. Push the meter in panel slot
(size 92 x92 mm), it will click fit into panel with the four integral retention clips on two sides
of meter.
If required Additional support is provided with swivel screws (optional) as shown in figure.
Easy Clip
-
in
mounting
Swivel screw
As the front of the enclosure conforms to
IP 50. additional protection to the panel may
be obtained by the use of an optional panel
The EINE V/A should be mounted in a
reasonably stable ambient temperature and
where the operating temperature is within
0
the range 0 to 50 C . Vibration should be
gasket. The terminals at the rear of the
product should be protected from liquids.
kept to a minimum and the product should
not be mounted where it will be subjected
to excessive direct sunlight.
11
To Next Page
Loading...
