RiteAid deluxe automatic - Page 19

5.6. Memory — Displaying the last 99 Measurements
At the end of a measurement, this monitor automatically stores
each result with date and time. Thisunit stores 99 memories.
Viewing the stored values
With
the
unit
off,
press
the
“M"
button.
The
display
first
shows
“A",
then shows an average of all measurements stored in the unit.
Pressing the "M“ button again displays the previous value. To view
a particular stored memory press and hold the "M" button to scroll
to that stored reading -
Memory
full
_
When
the
memory
has
stored
,gg
resultsra.
new
.measuyed_.valu8
is
stored
by
overwriting
the
oldest
value.
I
,
Clear all values
If you are sure that you want to permanently remove all” stored Val— .. '
sues, hold down the "M" button (the instrument must have been
switched
off
beforehand)
until
"CL“
appears
and
then
release
the
button. If you do not want to clear the values, press the ‘ '
START/STOP button; To permanently clear the memory, pressthe
“M"
button
while
"CL"
is
flashing.
Individual
values
cannot
be
cleared,
5.7. Discontinuing a Measurement
If it is necessary to interrupt a blood pressure measurement for any '
reason (e. g the patient feels unwell), the START/STOP button can
be pressed at any time. The device then immediately lowers the -
cuff pressure automatically.
17: