RiteAid deluxe automatic - 6. Error Messages and Troubleshooting; Understanding Error Codes and Malfunctions

6. Error Messages/Troubleshooing
lfan error occurs during a measurement, the measurement is diScontinued _
and
a
corresponding
error
code
is
displayed.
We
recommend
you
switch
L. -
the device off and take a new measurement making sure you allow time L.
for relaxation (example: error no. 1 l. :
Error
No.
Possible
causels)
ER 1 ‘ The tube may have loosened, or no pulse
was detected.
.
*Ensure
cuff
connections
are
tight
with,
,
proper cuff placement. ”See section (5.3):
ER ’2‘ Unnatural pressure impulses influence
‘
the
measurement
result.
Reason:
The
arm was moved during the measurement
(Artfact).
ER 13 ' Inflation of the cuff takes too long. The
‘
cuff
is
not
correctly
seated
or
the
hose
connection is not sealed.
~ER,.51' ' _. . The difference between systolic and
diastolic is excesive. Measure again
carefully following proper cuff proce-
dures and ensure measurement under
quiet conditions. Contact your doctor if
this message occurs frequently.
Hi . . The cuff pressure is too high. Relax for :5:
, _ . minutes and repeat the measurement.*
L0
.
-
‘
The
pulse
is
too
low
(less
than
40).
Repeat the measurement.*
*If
this
or
anyotber
problem
occurs
repeatedly.
please
consult
your
doctor.
21
\\7