RiteAid deluxe automatic - Page 24

Other
possible
errors
and
their
solutions
._
_
~.
-
'-
:
. .
.
‘If problems occur when using the device, the followrng points should be checked
Malfunction
The display remains blank when the
instrument
is
switched
on
although
the
batteries are in place.
Remedy
_
_
_
0
Check
battery
installation
or
AC
adapter
con—
nection is correct and wall outlet is working;
0 If the display is unusual, remove the batteries
and
then
exchange
them
for
new
ones.
Check
polarity
The
pressure
does
not
rise
although
the
pump
is
running.
‘
The device frequently fails to measure, or
the values measured are. too low» or high.
0
Check
the
connection
of
the
cuff
tube
and
connect properly.
1. Ensure the cuff fits properly. (see 5 3)
2. Before starting measurement make sure
that
the
cuff
is
not
too
tight
and
that
clothing
is
not
exerting
pressure
on
the
arm. Take articles of clothing off if necessary.
3’
3.
Measure
blood
pressure
again
in
complete
peace and quiet.
Every
measurement
results
in
different
val-
ues, altho‘ughthe device functions normal-
Iy and normal values a're‘di’splayed.
.l‘l; ‘.
0
Please
read
the
following
information
and
the points listed under 'Common sources
of error".(5.2) Repeat the measurement.
0
Blood
pressure
changes
constantly.
The
observed readings may accurately reflect
your pressure.
Blood pressure values differ from thoSe
measured by my doctor.
0
Record
daily
values
and
consult
your
doctor.
0
Pressure
readings.
In
your
doctor's
office
may be higher due to anxiety.
After the instrument has inflated the cuff" '
the pressure falls very slowly, or not at all.
(No reasonable measurement possible).
{Check
cuff
connections.
_
_
Ensure the unit has not been tampered with.
)
l.‘-.
‘l' -. G~lfil )3
:,l 11' ja;.\.! l: