14
1. When entering the field from transport, find a location that is as level as possible and stop the trac-
tor / roller.
2. Remove all wing axle safety lock pins and tee lock pins.
3. While moving forward in low gear, feather wing axle wheels by activating the hydraulic steering cyl-
inders to maximum angle (approximately 45 degrees) - the slow moving sign will indicate the posi-
tion.
4. Continue to drive forward slowly, wings will open to about 45 degrees, Stop.
5. Feather wing axle wheels back to straight (transport) position while backing up.
6. Continue to back up until the draft arms / swing arms move into the cam lock sockets.
7. Activate the hydraulics to lower the unit (roller drums) to the ground, hold hydraulic lever until the
wing axles are fully raised.
NOTE: Ensure that all wing transport locks are fully open and draft arm lock is fully closed.
NOTE: F3 (3 Section Roller) does not use / require wing transport lock.
To Next Page
Loading...