To Next Page
K
Kelly GrahamSep 2, 2025
What to do if my Rivacold Air Conditioner has a dirty filter on oil return?
- WwashingtonchristopherSep 2, 2025
If the filter on oil return is dirty in your Rivacold Air Conditioner, clean or replace it.
What to do if my Rivacold Air Conditioner has a dirty filter on oil return?
If the filter on oil return is dirty in your Rivacold Air Conditioner, clean or replace it.
What to do if my Rivacold Air Conditioner has a closed shut off valve on oil return pipe?
If the shut off valve on the oil return pipe is closed in your Rivacold Air Conditioner, open it.
What to do if my Rivacold Air Conditioner has clogged discharge pipes?
If your Rivacold Air Conditioner has clogged discharge pipes, clean the clogged discharge pipes.
What to do if my Rivacold Air Conditioner has suction pipes not correctly insulated?
If the suction pipes of your Rivacold Air Conditioner are not correctly insulated, insulate them correctly.
What to do if my Rivacold Air Conditioner has inadequate cooling water flow?
If your Rivacold Air Conditioner has inadequate cooling water flow, check and improve the cooling water flow.
What to do if my Rivacold Air Conditioner has excess refrigerant?
If your Rivacold Air Conditioner has excess refrigerant, remove the excess refrigerant from the system.
What to do if my Rivacold Air Conditioner has an expansion valve failure?
If your Rivacold Air Conditioner's expansion valve has failed, replace it.
What to do if my Rivacold Air Conditioner has clogged liquid pipes?
If the liquid pipes in your Rivacold Air Conditioner are clogged, clean them.
What to do if my Rivacold Air Conditioner has ice formed on expansion valve needle?
If ice has formed on the expansion valve needle of your Rivacold Air Conditioner, remove the ice.
What to do if my Rivacold Air Conditioner has a clogged suction filter?
If your Rivacold Air Conditioner's suction filter is clogged, you should clean or replace it.
General| Brand | Rivacold |
|---|---|
| Model | FSM012Z001 |
| Category | Air Conditioner |
| Language | English |
Details the installation procedure for the evaporator unit, including fixing to the cold room wall.
Explains how to connect the suction and liquid line piping, specifying diameters and installation requirements.
Specifies insulation requirements for suction line pipes to prevent condensation and overheating.
Explains the importance and procedure for setting vacuum in the system to ensure low air and humidity contents.
Details the process of charging the system with the specified refrigerant, including safety precautions.
Emphasizes the importance of checking for refrigerant leaks due to smaller molecular dimensions of new gases.
Details the electrical connection requirements, safety measures, and wiring instructions.
Describes the function of each button and LED on the control panel for operation and monitoring.
Explains how to turn the Blocksystem on and off using the ON/OFF key.
Details how to adjust the coldroom temperature setpoint via the control panel.
Explains how to access and modify system parameters, divided by security levels.
